What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
10.06.2025 18:05

Here is a simplified AC power diagram.
In schematic diagrams this is the symbol for a fuse:
2024–10–16 [ OO OLAOYE OYEBODE ]
United-JetBlue Tie Up Leaves American Airlines Bloodied - Live and Let's Fly
It also is a device that limits the change in current flow.
He then describes Rainy Season and Lightning.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
Newspaper headlines: Britain 'battle ready' and 'new Maddie search' - BBC
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
But… the neutral is now “floating” because of the 1 ohm resistance.
Kyle Busch, Josh Berry go sliding in practice at Nashville - NASCAR.com
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
At one ohm, the resistor has a maximum of 1 watt power.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
but I think this circuit , shows a few more pieces.
It seems Mohan does not understand the difference between a comment and an Answer.
Bitcoin Price, XRP Fall. The House Just Introduced a New Crypto Bill. - Barron's
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
The other is “what does a “fuse” do?”
This device then solves the entire problem.
A fuse is a non-resetable over current circuit protector.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
He then describes the function of a fuse.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
This one hit behind the barn.
Yuen: When cancer struck a second time, she found ‘euphoria’ - Star Tribune
There are two important concepts here.
These are simplified answers to the original question, and does not change anything I wrote above.
Because the load is inductive, the current lags the voltage.(by a bit).
Nintendo Switch 2 launch: GameStop investigating claims of console damage - NBC News
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
2024–10–14 [Omar Gharbi Omar Gharbi ]
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
The third is lightning and “how it gets conducted into a home.”
How corporate America learnt not to mess with Texas - Financial Times
a photo is worth a thousand words.
I post the exact comment here.
nine
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
Edit 2024–10.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
the problem then depends on "how fast does the fuse operate?".
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
This is where this question deviates from being a 'generic' question, and becomes more specific.
At least they know the answer if they wanted it.
He then asserts :
eight
There are three different concepts here that are getting confused.
What does a fuse do?
[image of Common-mode choke]
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
These devices are installed between the “hot” and “neutral” and protective ground.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
This is 'the assistant's answer'
but this device (an Inductor) … impedes the rapid changes in the current.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
Upvotes:
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
what exactly is a ‘surge’ protector?
Now when you have a certain ac resistance, then a current flows in a loop.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
First Sentence:
A circuit breaker is similar, but is resettable.
The bolt then partially travels down the line to your home.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
2024–10–10[John johnson John Johnson ]
What is lightning?
(Dc diagram shown, AC is similar).
But it can get overloaded, and no longer works.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
So, the voltage could go up to 500 volts, and the fuse will not open up.
One
One is “what exactly is in a ‘surge protector’ ? ”
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
This is where the MOV conducts again, and dissipated the energy.
[old diagram got deleted by accident]
For this case there are devices called Metal oxide varistors (MOV).
The MOV will conduct when the voltage exceeds 50% of line voltage.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
so, what happens?
Barnstars:
An AC voltage/ current source, and an ac inductive load.